Home > Canon Eos > Canon Eos Rebel T3 Error 01

Canon Eos Rebel T3 Error 01

Contents

Perhaps most importantly, by understanding a bit about error codes, they provide at least a chance that photographers can avoid unnecessarily tying-up equipment and sending it off for service, if it If you have multiple memory cards, format another memory card and take some test shots. and many people have suggested trying to manually clean the lens contacts. Anyway, it either the camera body or the lens is broken, it's not worthwhile to send them to canon for repair. http://hammerofcode.com/canon-eos/canon-eos-rebel-xsi-error-99.php

This may or may not solve your problem. I think it could be due to moisture where you shoot. APS-C Canon Xti Repair - Part 2 Canon EOS Error 01 (Err01) - The worst case scenario Konica AR Mount Lens on Nikon F-Mount New Breed of Digital Cameras Sky is share|improve this answer edited Jun 30 '12 at 13:45 mattdm 90.4k29263510 answered Jun 30 '12 at 11:03 simona 211 add a comment| up vote 2 down vote This is old question

Canon Eos Rebel T3 Error 30

Bezig... You'll end up doing more damage. the contact could be oxidised by the water vapour perhaps ? Station 90.187 weergaven 21:30 Sensor Cleaning: Stay Focused with Doug McKinlay - Duur: 8:49.

Hanno says: November 25, 2013 at 10:07 am Same prob here. Cannot clean sensor Description: There is insufficient battery power causing the shutter to close during the cleaning of the image sensor and the shutter curtains, resulting in possible damage to the The dashboard light doesn’t tell the driver WHAT exactly is wrong… only that the car’s electronic system has detected some sort of disturbance or anomaly. Canon Eos Rebel T3 For Dummies Then, clean the contacts on the camera.

Although, I should probably contact Canon first to see if they can help me locate the part. Canon Eos Rebel T3 Manual Canon EOS Error Messages: An explanation and understanding February 06, 2012 1 2 3 Single Page Font+ Font- Print Email Glossary On Off "EOS digital SLRs can display a series of Logged dgatwood 1D Mark IV Posts: 924 300D, 400D, 6D Re: Canon Rebel XTI Error 01 « Reply #10 on: November 30, 2014, 07:53:45 PM » Quote from: gabbielynn on November Serge Ramelli 89.939 weergaven 10:11 35mm vs 50mm - Best First Prime Lens? - Duur: 6:15.

The lens motor overloaded the camera. Canon Eos Rebel T3 Video This error can occur for the following reasons: You are trying to play back images captured with a non-Canon camera. Quote from: dgatwood on November 30, 2014, 07:53:45 PMQuote from: gabbielynn on November 28, 2014, 08:12:56 PMthanks for your reply. I read through the solutions.

Canon Eos Rebel T3 Manual

Best way is to buy a used donor that has different problem such as broken LCD or power supply. Clean the lens contact." Well, life can't be that simple can it? Canon Eos Rebel T3 Error 30 Err 70 Description: A malfunction with the images has been detected. Canon Eos Rebel T3 Review Wildlife Photo Contest SlideshowFeatured Member: Yan ZhangPro Sports Photographer Story Err 01 Communications btwn camera and lens is faulty.

I don't think my contacts need cleaning because the camera works fine with a 18-55mm lens. news When I try to change it there are no values. Common problem with several zoom lens models. If you're handy with fine electronics and lens disassemble/reassemble you can find a replacement cable cheap and DIY. Canon Eos Rebel T3 Accessories

I then remembered a computer geek who told me a story about print cartridges. Hope that helps, it worked for me! You might be surprised that it won't cost that much and cheaper than buying a new one. have a peek at these guys Thanks.

I had the camera serviced by the store where I bought it and when it came back they claimed to have "replaced DC/DC PCB ASS'Y, repaired contacts unit, cleaned, checked and Canon Eos Rebel T3 Video Recording Reply Reply with quote Complain Olga Johnson • Forum Pro • Posts: 22,591 Re: Err 01 - Communications between the camera and the lens... (both 7D and 60D) In Reply to thread Reply with quote Complain Peace On Earth • Contributing Member • Posts: 699 Re: Err 01 - Communications between the camera and the lens... (both 7D

Seleziona la lingua dall'elenco in alto e automaticamente si visualizzeranno tutti i contenuti disponibili in quella lingua; diversamente la lingua di default sarà l’inglese.

I had this problem with a Canon 5D MKIII and a 24mm f 1.4. In reply to Newtophotography • Apr 9, 2014 Newtophotography wrote: MiniMayhem wrote: Hi- I've been searching an answer for a similar problem and came across the suggestion to shoot in AV Or, the camera may seem to return to normal for a while, but the same error message may return one or more times. Canon Eos Rebel T3 Vs T5 Resolution: Set the [LOCK] switch to the left to release it and enable the functions.

Eric Rossi 41.182 weergaven 7:34 How to Clean Your DSLR Sensor and Mirror - Duur: 7:31. When a newly formatted Compact Flash card is installed, the folder number starts from 100 and the image file number starts from 0001. Reply Reply with quote Complain shihan969 • New Member • Posts: 1 Re: Err 01 - Communications between the camera and the lens... (both 7D and 60D) In reply check my blog Since the error codes do point to some specific areas, this can be helpful in trying to at least isolate where the problem is.

and contributors. It was new and the 5D was only about three years old. If the problem is due to dirty lens contacts, this might fix it. 1. The ones in the camera are spring loaded...

Holy crap! What should you do if you encounter an error code? Gepubliceerd op 4 apr. 2013I was getting an error message that said "Communications between the camera and lens is faulty. When the car is brought into a service facility, a technician with an on-board diagnostic tool (OBD) can connect the instrument to the car, and get a specific read-out of what

If so, you’re probably good to go. LOG IN TO REPLY chrstrchrstrHatchling6 postsJoined Jun 2012More infoJan 03, 2013 01:21 as a reply to kylekruchok's post|#7I had this problem with my 50L, and noticed that the aperture blades appeared Good luck.jordy2324 wrote:So while I was shooting this past Saturday, I had this error:"Err 01 Communications between the camera and lens is faulty. Big thanks to MiniMayem.

Try clean and check the contacts on the lens and pins inside the camera again. I then tried the lens on my 60D.